Solve the problem of leaking water purifier killer

Pressure test, test, I ran more than 500 water purification plants, a complete suite of test equipment pressure test only Patio, beautiful, open can, very few stand several upgrades, most of the factory test pressure test device can only increase the static pressure, can not measure dynamic pressure and burst pressure pulse, and some have never even done a pressure test. Only now developing national standards for water purifiers for three pressure test requirements is estimated to improve the quality of water purifiers, especially leak-proof water will help, but is recommended as the standard, non-enforcement, small factories ignored, nor will be implemented.
On-site installation quality is also very important. For example, the cartridge filter built well, screw cap, can not be too loose, too loose will leak; can not be too tight, tight rubber band will cause distortion and leakage. Therefore, installers must be trained.
Connector loss is a common fault leakage, mainly due to the principle of joint is not perfect, and installation work is not in place. German-owned Water World Baokang (Nanjing) Co., Ltd. specializes in serious, repeated tests, the development of new water-tight, do not fall off the pipe fittings, has obtained national patents, about mass production, the water leak on the water purifier is definitely a blessing. Traditional fuel nylon quick connector and pawl, water seepage and off easily; Korea DMT quick connectors use seals and pawl, but such as the installation is not in place, or forget to install the locator card, the park is not enough water, ultrasonic welding is not strong and the front cover off so will result in leakage and flooding, the world’s joint Baokang improve these shortcomings, the water in the water park to increase plugs correction degree, two-way sealing ring seal through the side and face, the front cover with nuts to the locking pawl, greatly improving the reliability of joints, seepage rate, leakage rate is almost zero.