It is said that the dump truck is "a seven-point support and a three-point maintenance". Repairs must also be focused on maintenance. How to repair, how to maintain, please see here. The driver usually cherishes every part of the car while driving the dump truck and must learn basic maintenance knowledge. How to look at "three oils, three waters" is the most basic maintenance knowledge, the so-called "three oils, three waters" is the oil, transmission oil, brake oil, water tanks, wiper water, battery water, the average driver to see these are still very understanding of.
The driving tipper suddenly shuts off, and many drivers will encounter this trouble while driving. At this time, the drivers are better not to care about the horns of the rear car and relax their emotions. Follow the coaching start-up procedure when learning the car: Lift the clutch and lightly lift the throttle so that the vehicle moves slowly forward. If this cannot be started, it is very likely that the dump truck has failed and it is not possible to start it. It is imperative to rush to the repair service station to ease the call.
The pressure of the tipper tires can be checked visually. This should be fine for any driver. As long as the tipper tires are awkward, the tipper pressure is too low and it is sufficient to inflate the tires at the repair station. As for the brake system, this can also be felt when leaving for snacks. When it is found that the brake of the dump truck is not too sensitive, it is time to go to the service station for inspection.
Dumping a puncture tire is also a troublesome thing. In remote areas, you cannot find any service station and you have to change your tires yourself. Professionals will teach you to easily change the spare tire: first, use a jack to slightly support the dump truck, and loosen the fastening nuts of the wheel before the free dump truck tires have left the ground. After loosening the tightening nut, continue to use the jack to support the dump truck. After the tire is completely off the ground, remove the original tire, install the spare tire, and evenly tighten all fastening nuts in diagonal order. Tighten the ground and finally lower the jack and finish the job of replacing the dump truck tires.
The application of two-dimensional and three-dimensional cutting methods realizes the processing requirements for shredding and dicing frozen meat and fresh meat. In restaurants and butcher shops, you can easily shred and ground fresh meat. In factories and catering processing workshops, you can cut frozen meat into beautiful strips and cubes. Regardless of whether it is a two-dimensional or three-dimensional cutting machine, you can change the cutter to meet the needs of different cutting sizes.
Shijiazhuang EFU Machinery Co., Ltd , https://www.efuequip.com