Chrysler said that as of the end of March, the company’s cumulative sales of global automobiles in the first quarter of 2011 were 394,000 vehicles, up 18% year-on-year. However, this figure is still far behind the company’s CEO Sergio Marchionne’s expected 32% year-on-year increase in car sales.
Malchone plans to increase Chrysler’s global sales this year to 2 million. In addition, he also plans to get Chrysler out of the dilemma and make it realize its first full-year earnings in 2011 after the company's 2009 bankruptcy reorganization.
Mike Manley, the head of Chrysler’s international business, said in an interview recently that once the company has more new models or improved models introduced in Europe, its car sales growth outside North America will increase. It will improve.
Chrysler spokesman Ralph Kisiel said that in March, the company sold 13,996 vehicles outside of North America, up only 1.6% year-on-year. In February, sales of cars outside North America rose by 8.6%.
It is reported that in March the company's best-selling car outside North America was the Jeep Wrangler, which sold 2,256 vehicles in March.
The solution, emulsion, suspension liquid or slurry are sprayed into fine beads in the hot air, going down from the top of the drying chamber to the bottom, the water will be evaporated to and the product becomes small granular product. Induce hot air from the top of drying tower, at the same time, pump the material liquid to the top of the tower by high pressure pump, the feeding solution becomes fine beads or small droplets through the pressure nozzle(s). When the droplets meet the high temperature hot air, the water will be evaporated immediately, and the material liquid is dried into dry product in a very short time, the product is discharged from the bottom of the drying tower, or from the cyclone (depend on the configuration). When the hot air contacts with the droplets, the temperature declines significantly, and the humidity increases greatly, and then will be exhausted by exhaust fan. The fine powder in the air will be collected through different separating devices There`re different fine powder separation and recovery devices, such as cyclone (the common type and various combination type), bag filter, cyclone + bag filter, cyclone + wet scrubber, and bag filter + wet scrubber etc. We should different fine powder separation and recovery devices as per the characteristics of product and requirements of customer. Depend on the product features and requirements, we might install secondary drying and cooling system (such as ZLG vibration Fluid Bed or pneumatic transportation), formulation system or powder sieving system etc after the Spray Dryer, or dehumidifier. The particle size of the product from Pressure Spray Dryer is normally within the range of 120mesh to 20 mesh. If bigger particles are required, we suggest FL Fluidized Granulator or re-combined agglomerator.
Pressure Spray Dryer,Spray Drying Equipment,Spray Drying Food,Spray Dry Powder
Griffin Technology Manufacturing Co., Ltd. , https://www.griffindryingeqpt.com