Landscaping dedicated sprinkler

Urban greening is the main means of urban ecological environment construction. From a scientific point of view, the aim of urban afforestation construction should be to improve the environment, achieve a harmonious coexistence between man and nature, benefit the people's physical and mental health, and facilitate the overall coordinated and sustainable development of society. We must integrate urban afforestation with beautifying environment and economic benefits scientifically, and let afforestation really be a beneficial move to improve and beautify the environment, benefit the society, and benefit the children and grandchildren. The green sprinkler truck is specially used for garden seedling protection, urban afforestation, factory dust removal, fire sprinkler and road flushing. It is an indispensable tool for landscaping.

2

The green sprinkler is powered by the vehicle gearbox PTO. The power is transmitted from the drive shaft to the pump. The pump is operated at the rated speed. The liquid is sucked into the tank according to the set function, or the liquid in the tank is passed through. Pumps are pumped out of the tank to complete the dedicated functions of the green sprinkler.

3

Sprinklers need to pay attention: Do you know under what conditions the green sprinklers are not allowed to work on the road? Old drivers with certain driving experience surely know that the sprinkler sprinkles water and rain is the same wet ground, but under the rain through the car Walking on the road is not easy to slip; but the sprinkler sprinkles water over it, as if pouring a layer of "oil" on the road, let you be careful and careful, this layer of "oil" will always give you a dangerous situation. Of course, it's not that a sprinkler will have a traffic accident when it comes to sprinkling water, but that it should reduce the danger as much as possible. Therefore, the state stipulates: 1. No watering is allowed below 0°C. /2 Sprinklers: From 9:30am to 12:00am, from 2pm to 5:30pm, sprinkle water mildly to deal with large amounts of accumulated water in time. Machine sweeping time is from 5:30 in the morning to 7:00 in the morning, from 10:30 to 12:00 noon, and from 3 to 5 in the afternoon. Mainly to clear the road surface, the road will be slightly wet during the cleaning process, but will not cause a lot of water.


The die casting part production flow chart

Die casting production flow chart

Injection speed of die cast process

Pouring liquid metal tie up chamber volume percent

Injection speed(cm/s)

≤30

30-60

>60

30-40

20-30

10-20


High speed computing formula

High speed computing formula

V -------------Cavity volume (CM3);

N ------------ Cavity No;

D ------------ Die-casting drift (CM);

T ------------- Proper filling time.


The production of aluminum and Zinc Alloy Die Casting parts.

Production of aluminum and zinc die casting parts









Die Casting Parts

A380 Aluminum Die Casting, Aluminum Die Cast Part, Die Casting Parts, Zinc Die Casting

NINGBO BEILUN LEMA MACHINERY TECHNOLOGY CO.,LTD , http://www.china-lema.com